CONCEALED ELECTRIC HEATING · DRYLINING
DRYTEC infrared heating film brings radiant warmth into suitable plasterboard ceilings and walls. It is designed for projects where heating can be integrated while the drylining is being installed, leaving the finished room free of wall-mounted radiators.
Heating designed around dry construction
E-NERGY CARBON DRYTEC attaches to a compatible drywall substructure before the boards are fitted. Its side mounting strips provide fixing areas outside the active heating zone. This makes the installation sequence particularly relevant to new builds, modular construction and refurbishments where ceilings or walls are already open.
A concealed finish
Plan the heating within the ceiling or wall build-up so the finished surface remains clear.
Drylining workflow
Coordinate the electrician and drylining contractor before boarding begins.
Room-by-room control
Specify compatible thermostats and power supplies around the areas you use.
DRYTEC specification and compatibility
| System type | Electric carbon heating film for drywall ceilings and walls |
|---|---|
| Film thickness | 0.4 mm |
| Supply to the film | 36 V safety extra-low voltage through the specified power supply |
| Current manufacturer geometry | 410 mm active area with two 95 mm side mounting strips |
| Boarding | Manufacturer describes compatible drywall boards up to 12.5 mm; confirm the complete build-up for your project |
Dimensions and output must match the exact product supplied. Confirm the current UK specification, support spacing and fixing layout before ordering; do not substitute an older installation detail.
Planning your DRYTEC installation
- Establish the heat demand. A room-by-room assessment should consider insulation, glazing, room size and the temperatures required.
- Agree the available heated area. Mark lights, access panels, beams and other services on the ceiling plan.
- Specify the electrical system. A qualified electrician should check supply capacity, protection, cable routes, sensors and accessible power-supply locations.
- Record and commission the installation. Follow the supplied instructions and keep the layout available for future work.
For a wider view of the installation choices, see our infrared ceiling heating guide.
DRYTEC questions answered
Can it heat an entire room?
That depends on the room’s calculated heat loss, approved output and usable heating area. The design should demonstrate that the selected system can meet the requirement.
What will it cost to run?
Use expected electricity consumption and your tariff to estimate costs. Installed wattage alone does not show annual consumption. See our running-cost guide for the calculation and assumptions to request.
Can I cut or drill the film anywhere?
No. Any permitted cutting, fixing or penetrations must follow the instructions for the exact supplied product. Keep a record of heating zones and electrical connections.
PLAN YOUR PROJECT
Find out whether DRYTEC suits your building
Send your floor plans, room dimensions, construction details and proposed installation date. We can discuss the specification and information needed for a quotation.
Request a DRYTEC consultation